Need Help!- Help on my small list

[MadKad]

Hi sorry to start a thread like this

I was just making sure that this will work before I order, as I allways have bad luck when buying things like this =

This = HobbyCNC EZ Driver Board Kit
http://www.hobbycnc.com/products/hob...ver-board-kit/

with 3 x NEMA 23 1-Amp Unipolar Stepper Motor

using the Daisy chaining computer PSU idea of 3 psu's
http://www.cnczone.com/forums/showthread.php?t=17548

The psu's I have allready as I have 100's of computer stuff, but might not use that idea yet I just thought I would ask aswell.

This is for a router / engraver table I want to build its going to be no more than 12" x 12" for the table.

any thoughts?

as I am trying to keep cost low but have a nice machine.

[MadKad]

also I forgot to ask, with the HobbyCNC EZ Driver Board Kit I will not need any other driver boards or anything like that will I?

[MadKad]

Any one help on this?

[MadKad]

I will just get them and find out

[Ron111]

MadCad,
Sounds like you have the plan down. The board has the breakout board function built in to it and you will only need to cable up the motors to it. I used one on a lathe that I converted a while back. Just take your time sodering the components and be careful to prevent solder bridges. Are you planning to use mach3?

Ron

[MadKad]

Hi thank you for your reply

I am unsure what software to use yet, I want a software that is good, cheep and easy to understand I havent looked into them much yet, but I really want a software that I can just place pictures on and it do the coding from that :-S