Fet-3 Machine - CNCzone.com-The Largest Machinist Community on the net!

clarsum · #1 05-28-2008, 08:05 AM

I am just guessing, but I think that my setup is all wrong. I am trying to find out what my Pin setup is supposed to be. Anyone help!
Clarsum

johnmac · #2 06-01-2008, 10:52 PM

Have you tried the step program from Stepper World? If you can get your steppers to turn and change direction with it, then the problem is in the controller program. (Mach or Kcam).

John

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
saleCNC laser engraving machine and CNC woodworking machine	zhangrui1588	Laser Engraving & Cutting Machines	3	05-08-2011 03:54 PM
machine gun noise on a haas machine	serviceman	Haas Mills	0	03-03-2008 11:17 AM
Deep Groove Taig machine would it be a good starter machine	Fritzie15	Taig Mills & Lathes	0	09-20-2007 09:37 PM
paper printer machine like cnc machine ???	patriciooholegu	Mechanical Calculations/Engineering Design	3	08-07-2007 08:19 PM
Use Machine Shop vs. Buying Machine	imp22b	General Metalwork Discussion	15	06-06-2007 06:33 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)