| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Stepper Motors and Drives Discuss stepper motors, drivers and related topics here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-27-2008, 07:08 PM
| |||
| |||
I have a luminart sign machine, vintage 1995ish... I think it is made by Precix. I am trying to find information on the 4 axis (only 3 axis populated) stepper board that they used in the machine controller. Contacted Precix, but after a few reminders, still nothing back. Have attached a picture. I am planning in interfacing to a parallel port and need to figure out the pinouts. The current controller configuration is for HPGL only, via RS232, and it will not link up to the software, so I want to dump the controller and interface directly to the stepper board. Anyone have any information on this board? Manufacturer, manual, experience, suggestions??? Eric  |
|
#2
04-30-2008, 06:42 PM
| |||
| |||
| Anyone???? |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Newbie- Convert/Retrofit old Precix HPGL controller to G-code | Blluitt | Commercial CNC Wood Routers | 30 | 01-13-2012 10:42 PM |
| Precix Router Industrial series | juanleal | Commercial CNC Wood Routers | 14 | 03-10-2008 04:20 PM |
| precix vaccuum table | joemc | General Metalwork Discussion | 0 | 10-18-2007 07:47 AM |
| Larken, Techno, Precix, or used? | Drassk | Commercial CNC Wood Routers | 6 | 06-16-2007 10:47 PM |
| Precix Cnc Router with a ATC | dighsx | G-Code Programing | 6 | 07-01-2006 05:29 PM |
| | |
Luminart (Precix?) Controller 
Linear Mode
