MAE stepper motor - CNCzone.com-The Largest Machinist Community on the net!

andersbrun · #1 04-25-2008, 02:04 PM

Hi

I wonder if anyone can help me with the following:

I have a stepper motor from MAE with this tech. info:

HY - 200 -3437 - 460 A 8

N4 FASI-4,6A/FASE - 0,55 ohms

This stepper motor is located in the z-axsis of my terco cnc 45 bench top mill. I 'm planning to retrofit the mill with new stepper drivers and the rest of the mill is equipped with sanyo denki steppers type 103-807-7.

Are these steppers ok today...with for instance gecko drivers?

Best regards
Anders

Zappautomation · #2 04-25-2008, 04:18 PM

Its a good motor.
Lower torque than newer motors, but will work well with most drivers.

Originally Posted by andersbrun

Hi

I wonder if anyone can help me with the following:

I have a stepper motor from MAE with this tech. info:

HY - 200 -3437 - 460 A 8

N4 FASI-4,6A/FASE - 0,55 ohms

This stepper motor is located in the z-axsis of my terco cnc 45 bench top mill. I 'm planning to retrofit the mill with new stepper drivers and the rest of the mill is equipped with sanyo denki steppers type 103-807-7.

Are these steppers ok today...with for instance gecko drivers?

Best regards
Anders

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
use satellite dish actuator motor as a stepper motor	ozni	Stepper Motors and Drives	7	06-18-2010 07:55 PM
stepper motor help	mzungu	DIY-CNC Router Table Machines	2	01-22-2008 07:56 AM
Beltdrive-stepper motor-stepper motor driver	Georg	Stepper Motors and Drives	0	10-16-2007 04:56 PM
servos motor controled by stepper motor driver?	mike10	Servo Motors and Drives	1	01-03-2005 05:05 PM
Win stepper motor	CNCadmin	General Electronics Discussion	0	02-25-2004 10:05 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)