newbie looking for advice

[shawnmor]

Hello all
just about finished my Joes R2 and i am looking for sources for all electrical parts in Muskoka Ontario 2 hrs north of Toronto or anywhere in Ontario
controlers, motors, and power supply
any sources would be great
i am not very up on what to get,as i am completely new to this and am learnig,but would appreciate advice so as to try and outfit it properly and as reasonably the first time so as not to have to learn by my mistakes at least on powering the machine, i will be doing mostly wood carving, suggestions as to sizes types,do i buy individual parts or look for a commplete kit
i am unsure as to how to match all the parts togeher for best results
i thank all in advance for any and all advice
Thank You again
Shawn

[ger21]

Why not just use the HobbyCNC package the most are using?

[shawnmor]

Thank You
I was just looking for advice as to the best most reliable way to go
i am a woodworker and hydro tech so as far as electronics i don't want any problems, mechanical and electrical i can handle, just not electronics
This site is of a great help and i would not have gotten this far
Thank You all for all the great helpand advice i have gooten by reading
Thanks again
Shawn