8 leads Stepper Motor with Encoder - CNCzone.com-The Largest Machinist Community on the net!

victor888 · #1 01-03-2008, 02:18 AM

Damn, I have this school project, stuck with a old Sanyo Denki 4 phase 8 leads stepper motor.

Can anyone show me where can I any relative information???

Thanks alot, Buddy

victor888 · #2 01-03-2008, 08:47 PM

I need a controller + Driver

What is the board look like?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Encoder for stepper motor driver	takeda	Stepper Motors and Drives	1	09-15-2007 12:21 PM
How to tell if my motor is Pulse encoder or quadrature encoder?	Darc	Servo Motors and Drives	0	07-22-2005 04:51 AM
attaching an encoder to stepper motor	serry	Stepper Motors and Drives	6	01-25-2005 04:37 PM
encoder-stepper motor	granado	Stepper Motors and Drives	2	11-29-2004 05:38 AM
Stepper motor with encoder?	buscht	Stepper Motors and Drives	3	07-12-2004 10:53 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)