| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Stepper Motors and Drives Discuss stepper motors, drivers and related topics here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-23-2007, 08:36 AM
| |||
| |||
Hello guys, I'm motor tunning my stepper motors unsing Mach3. They run smoothly. Makes very good sound goinf back and forth. The only thing is that when I release arrow key in Mach3, the motor obviously deaccelerates and stops, but doesn't stop as good as they starts. Before stopping, vibrates a little and make a little more noise. I tried changing acceleration , but olny improves the start, when coming so stopping, vibrates a little. Is this normal? Tks!    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I put Carriage stops / E-stops on the x&y Shoptask 1739 Gunmaster....I was bored lol | spunky1974 | Shopmaster/Shoptask | 0 | 06-30-2007 05:13 PM |
| What if the spindle stops? | WoodSnarfer | General Electronics Discussion | 1 | 02-19-2007 10:00 AM |
| VFD induces terrible vibration in 2 different motors. SOS | rashid11 | General Metal Working Machines | 3 | 10-06-2006 08:34 PM |
| Router stops during cycle | dee26 | Machine Problems, Solutions , Wireless DNC, serial port | 0 | 04-29-2006 05:38 PM |
| Crusader just stops | harvard5 | Machine Problems, Solutions , Wireless DNC, serial port | 2 | 09-20-2005 09:19 AM |
| | |
Linear Mode
