| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Stepper Motors and Drives Discuss stepper motors, drivers and related topics here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-21-2007, 10:07 PM
| |||
| |||
Is there any easy way to tell if the motor is good. When I tried to run them in mach3 they just buzz and can't seem to get the motor tuned?  |
|
#2
11-21-2007, 11:17 PM
| |||
| |||
| You will need to include what you are using for motors and drivers. Next would be taking a look at your connections to verify if the motor is wired to step the coils in a TEST MODE. Power supplies. Drag on the slide assembly. Then look into your output pulse data paramters in the software etc. Let the process of elimination lead you from the obvious to the curious. There is a needle there somewhere. Basically, if it don't work......it aint good, but it may not be the motor. Have you done any other tests to rule out the above? DC
__________________ Learn cause and effect through experience. Mastering those relationships is the "Common Sense" ability within the art of any trade. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Easy to build CNC Mill Stepper Motor and Driver circuit | Tom McWire | Open Source Controller Boards | 20 | 03-31-2010 10:09 AM |
| Good, Easy to machine Steel (not 12L14)? | Builder4wd | General Metalwork Discussion | 7 | 09-24-2006 09:33 PM |
| Not good for a stepper motor? | FLUTE HEAD | Stepper Motors and Drives | 4 | 12-01-2004 11:31 PM |
| Is this a Good Stepper Motor | Biggermens | Stepper Motors and Drives | 5 | 11-03-2004 05:57 PM |
| | |
Linear Mode
