| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Stepper Motors and Drives Discuss stepper motors, drivers and related topics here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-20-2007, 02:00 PM
| |||
| |||
Shown here is a wiring diagram of my drives and power supply. I'm confused on how to wire the drivers from the breakout board. Do I use the 5 volts ( switchable for com to 5 volts)from the C1 board to the Step+ and Dir+ or use the tap off the power supply? Do I then hook up my Step and Dir terminals from the BOB to the Step- and Dir- on the driver board? I can use all the help I can get. Wiring is not my thing!  |
|
#2
11-20-2007, 02:52 PM
| ||||
| ||||
| The step and direction signals should connect from your BOB to the drives. If you have an external 5VDC power supply, you can power your BOB from that. What drives are you using? Scott
__________________ Consistency is a good thing....unless you're consistently an idiot. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| G-REX wiring | Lost Tourist | G-REX | 24 | 07-30-2008 05:15 PM |
| Wiring help..... | fineartlig | Industrial Hobbies (Support forum) | 1 | 09-24-2007 11:21 AM |
| need help wiring | dtman | CNC Plasma and Waterjet Machines | 11 | 02-19-2007 07:55 AM |
| P5 Wiring | tintruder | Servo Drives | 2 | 02-03-2006 11:13 AM |
| Wiring help. | dmgdesigns | General Electronics Discussion | 3 | 04-16-2005 11:12 PM |
| | |
Linear Mode
