| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Stepper Motors and Drives Discuss stepper motors, drivers and related topics here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-17-2007, 11:50 PM
| |||
| |||
I'm gaithering parts for hobby cnc have most of mechanicals , ballscrews , linear guides & rail , table & gantry. Working on electrical now. Theres some 3phase oriental steppers with gear reducers at work that were taken off a job and are about to be tossed out. Supervisor says there good but just wrong. Would these be good for use on a hobby cnc if they are the right size or be better another kind such as 2 phase? Dont know much about this I'm a machinest. Thanks Tim  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 5-phase stepper driver? | skandragon | Stepper Motors and Drives | 5 | 04-03-2008 09:15 PM |
| VEXTA Stepper with 5 phase | kraft123 | Stepper Motors and Drives | 0 | 07-30-2007 02:04 PM |
| 3-phase stepper controller | extreme | Open Source Controller Boards | 0 | 06-20-2005 10:03 AM |
| 5 phase stepper | 2muchstuff | Stepper Motors and Drives | 0 | 03-29-2005 11:40 PM |
| 2 phase vs 4 phase stepper motors | Don C | General Electronics Discussion | 1 | 05-26-2004 01:40 PM |
| | |
Linear Mode
