Need stepper Drive to be used after Gecko G100 - CNCzone.com-The Largest Machinist Community on the net!

		CNCzone.com-The Largest Machinist Community on the net! > Electronics > Stepper Motors and Drives
Need stepper Drive to be used after Gecko G100

Stepper Motors and Drives Discuss stepper motors, drivers and related topics here.

This forum is sponsored by:

10-25-2007, 08:27 AM

vbrijkaushly vbrijkaushly is offline

Join Date: Oct 2007

Location: India

Posts: 1

Need stepper Drive to be used after Gecko G100

permalink

Hi,

I am looking for a good Stepper drive (Bipolar 3amp min) which I can use to drive the motor. It is basically a replacement for Gecko G201.

A proper and tested drive ckt with PCB layout is the exact thing I am looking at.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is Off HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mach3 and Gecko G100	johnd	Mach Wizards, Macros, & Addons	8	08-17-2008 03:20 AM
Stepper drive (Gecko) problem	LEWENZ	Gecko Drives	4	02-07-2007 09:46 PM
Gecko g100	Lloyd	Gecko Drives	0	10-24-2006 01:24 AM
Mach4 & gecko g100	efrem	Machines running Mach Software	4	07-14-2006 01:17 PM
Gecko Stepper Drive Box	camsoft	Gecko Drives	0	05-23-2006 05:34 PM

All times are GMT -5. The time now is 09:57 AM.