Few stepper specs needed and advise

[ikalafat]

Hi everyone.. i bought few steppers so i need datasheets or more information for them. Thanks

#1

5 phase stepping motor
A3851-9215
DC 1.3 A 1.4 ohms/phase
0.72 deg / step
FH7-1804
vexta, oriental motors
5 wires - black, green, yellow (orange?), red, blue..
Is this motor compatible for any CNC use?

#2
Type KH56Jm2U014
no 3408
japan servo co., ltd
6 wires, black, red, brown, yellow, blue, orange..
Is this motor compatible for any CNC use?

#3
Vexta
model C6957-9015K,
5 phase, 0.72 deg/step
DC 1.5A, 0.73 ohm,
VS7 69368,
oriental motors
5 wires - black, green, yellow (orange?), red, blue..
Is this motor compatible for any CNC use?

#4
Minebea,
p/n EM-181
type 17PM-H005-P2V
6 pins on connector..

Can i use first three motors in combination with this driver? http://cratel.wichita.edu/blogs/tomm...-motor-driver/

Thanks!

[ikalafat]

i'm totally dissapointed.. i have expected more from this forum.. i had great thoughts about cnczone.com itself... but if you can't answer at one question, i don't know what i'm doing here.. ****ing morons.. you won't see me around anymore..

[Oldmanandhistoy]

PMSL thanks ikalafat I needed that.

[Mariss Freimanis]

ikalafat,

I read your first message a few minutes ago. I wrote a complete and very helpful reply. I was ready to push the "reply" button when I read your second message. I pushed the cancel button and flushed the reply. Can you guess why?

Mariss