Vexta stepper motors

[Dave Rothermel]

I am new new to hobby cnc. I want to first build a router to gain experence.
Won't do anything till winter. Am now collecting stuff. My question is, I have two
stepper motors. They are Vexta A2934-9212 H-L4B They are 24 volt 0.3A/phase
1.8 DEG./step. I can't find anything about them. Would they be good for anything? Hope you can help me.
Dave

[ger21]

Would they be good for anything? Hope you can help me.
Dave

No good. Look for steppers in the 2V-6V range, the lower the better.

[w5kfg]

I am also new to hobby cnc. I have (4) vexta ph265-04-cp 5volt 1amp steppers from another project. Would these be good for a small cnc router project

[ger21]

I am also new to hobby cnc. I have (4) vexta ph265-04-cp 5volt 1amp steppers from another project. Would these be good for a small cnc router project

Not sure what the torque is on those, but probably just over 100oz. A bit on the small side, but would probably be OK on a very small machine, but it won't be too fast.

[shadowless]

hi ger21,

can i ask you if 3.8vdc stepper motor would work with low voltage drives such as gecko201 or parker oem650 drives?

Regards,
Wei