Clip Of L297+7409+irf520

[NASR1]

HI
here is a clip OF stepper driver with L297+7409+IRF520.
I hope to take pleasure.
nasr1

[servocontroller]

A very good effort.

[servocontroller]

Hi Nasr1,

Do you know any open source stepper motor project by which i can control my old cnc machine having steppers on it and using mosfet's

[kiwichris]

Hi Nasr1,

Do you know any open source stepper motor project by which i can control my old cnc machine having steppers on it and using mosfet's

have a look at www.pminmo.com... Lots of good stuff on there.

[EMMKAY]

Hi Nasr1,

Do you know any open source stepper motor project by which i can control my old cnc machine having steppers on it and using mosfet's

what volts and amps you need for your steppers. I have slightly changed a current chopping pminmo design for 100V 8amps per phase for unipolar motors. If interested drop me a pm.

EmmKay

[NASR1]

Hi Nasr1,

Do you know any open source stepper motor project by which i can control my old cnc machine having steppers on it and using mosfet's

HI
You can use this driver for 6AMP stepper motor.

[servocontroller]

Thanks all i need to perform practical

[EMMKAY]

Hi Nasr1.

Have you actually made the board you posted a schematic of..???? I am inetersted in finding out how did the irf's peformed and what kind of performance did you get out of it ...

[NASR1]

Hi Nasr1.

Have you actually made the board you posted a schematic of..???? I am inetersted in finding out how did the irf's peformed and what kind of performance did you get out of it ...

HI
that one sample of circuit.
i building completely with protel softwer.if you can working with protel softwer i attached for you.
regards
nasr1.

[moonoijj]

HI
that one sample of circuit.
i building completely with protel softwer.if you can working with protel softwer i attached for you.
regards
nasr1.

Hi Nasr1

Can you attached protel files for me?

regards

JB

[EMMKAY]

I am having problems accessing any of the attached files on this thread. Anyone else having the same ..???????