Drive a 2 phase servo with a step driver? - CNCzone.com-The Largest Machinist Community on the net!

		CNCzone.com-The Largest Machinist Community on the net! > Electronics > Stepper Motors and Drives
Drive a 2 phase servo with a step driver?

Stepper Motors and Drives Discuss stepper motors, drivers and related topics here.

This forum is sponsored by:

02-23-2007, 06:53 AM

Eson

Join Date: May 2005

Location: Sweden

Age: 25

Posts: 88

Drive a 2 phase servo with a step driver?

permalink

Is it possible to drive a 2 phase servo with a step driver? Isnt a step motor basically a 2 phase synchronous DC motor? I guess i have to drive it as open-loop.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is Off HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
3 Phase step up transformer?	DennisCNC	General Electronics Discussion	11	06-17-2006 07:50 PM
Advantages of 3 Phase Step motors	bunalmis	Stepper Motors and Drives	11	05-23-2006 04:45 PM
step and direction control for opto22 servo drive	drewgarth	Servo Motors and Drives	4	05-21-2006 01:31 PM
Servo motor, step/dir driver and Mach.	Darc	Mach Mill	0	04-11-2006 12:23 AM
Convert Step/direction to phase drive	jderou	Stepper Motors and Drives	18	08-05-2005 08:52 AM

All times are GMT -5. The time now is 04:39 AM.