Help for stepper controller with tripple l289 - CNCzone.com-The Largest Machinist Community on the net!

NASR1 · #1 10-11-2006, 02:58 PM

Hello all
Do any used of tripple l298 controller for 4amp stepper motor.
Any help appreciated.
Best regards.

pminmo · #2 10-11-2006, 05:17 PM

What you are doing ST advises against. The only paralleling they recommend is the two channels in the same chip. If your lucky enough to get the same die lot, you maybe ok. But you may trash all your chips the first time you power it up also.

NASR1 · #3 10-12-2006, 12:49 AM

Originally Posted by pminmo

What you are doing ST advises against. The only paralleling they recommend is the two channels in the same chip. If your lucky enough to get the same die lot, you maybe ok. But you may trash all your chips the first time you power it up also.

Dear pminmo
I am try to test.
Thank you in advance.

Best regards.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)