Results 1 to 3 of 3

Thread: 1st cut information webpage, Stepper Driver Electronics

  1. #1
    Registered pminmo's Avatar
    Join Date
    Jun 2003
    Location
    St. Peters, Mo USA
    Posts
    3,325
    Downloads
    0
    Uploads
    0

    1st cut information webpage, Stepper Driver Electronics

    http://www.pminmo.com/drivers.htm

    1st cut, it's 1AM, I just posted it, it is a mind dump, what have I missed, what needs clarified, technical mistakes, suggestions.........anything

    Phil, Still too many interests, too many projects, and not enough time!!!!!!!!
    Vist my websites - http://pminmo.com & http://millpcbs.com


  2. #2
    Registered pminmo's Avatar
    Join Date
    Jun 2003
    Location
    St. Peters, Mo USA
    Posts
    3,325
    Downloads
    0
    Uploads
    0
    Based on greybeards suggestions, 2nd cut.
    Phil, Still too many interests, too many projects, and not enough time!!!!!!!!
    Vist my websites - http://pminmo.com & http://millpcbs.com


  3. #3
    Gold Member High Seas's Avatar
    Join Date
    Sep 2003
    Location
    Malaysia/Australia/NZ/USA
    Posts
    1,126
    Downloads
    0
    Uploads
    0
    Phil - what a great piece of work! Sorta what was started a few years back - now if someone did the mechanicals, platform etc, 99% of the newbie queestions would be supported! Great - thanks - Cheers - Jim
    Experience is the BEST Teacher. Is that why it usually arrives in a shower of sparks, flash of light, loud bang, a cloud of smoke, AND -- a BILL to pay? You usually get it -- just after you need it.


Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.