| | |
Is the HobbyCNC driver board any good or is it like the tb6560 I have been looking for post about it and reviews but could not find any any reply or help will be appreciated thanks
I don't have one of those boards, but they seem to receive OK marks from people who do have them.
There is a whole section of this forum devoted to the HobbyCNC boards, and you might find some useful info there:
Hobbycnc (Products) - CNCzone.com-The Largest Machinist Community on the net!
"Ok marks"? Really? Search CNCZone.com for TB6560 and read all the people who have had problems with that driver or who have had it fry on power up after months of perfect operation. See:
http://www.cnczone.com/forums/steppe...60_driver.html for why.
James hosts the single best wiki page about steppers for CNC hobbyists on the net:
http://www.piclist.com/techref/io/steppers.htm Disagree? Tell him what's missing! ,o)
The "OK marks" comment was referencing the HobbyCNC boards, not the TB6560 boards.
I would not suggest that TB6560 boards get "OK marks"...
ah.. doorknob, sorry, my bad! I wasn't reading that with the attention I should have been giving it. What happens when I try to talk to a customer on the phone and post here at the same time!
James hosts the single best wiki page about steppers for CNC hobbyists on the net:
http://www.piclist.com/techref/io/steppers.htm Disagree? Tell him what's missing! ,o)
No problemo...
Posting Permissions
| | |
LinkBack URL
About LinkBacks
