Which motors for this cnc table?

[WarrenW]

I plan to build the cnc setup found at solsylva.com. For that size of table, which motors / driver is recommended? I went to hobbycnc.com but their driver board is a kit and I want a set all ready to go.

So then I went to Xylotex.com and he said the 269oz motors he had would not work on this table that it was too big. So now I'm really lost. I want to buy the motors matched with the driver board as a package. I am going to cut 1/8inch birch wood with this in patterns.

Any suggestion?

Thanks!

Warren

[ger21]

HobbyCNC will sell you the board assembled for an extra fee. The Solsylva site says his plans are designed to use 200 oz-in motors, and he mentions the Xylotex on his site. I'd send him an email and express your concerns to him.

[sol]

Sorry to have missed this post. Warren, and Jeff of Xylotex, and I have straightened out the confusion.
The Solsylva table can work with Xylotex's steppers.
Thanks for posting Gerry!