LinkBack URL
About LinkBacks
Well with my HobbyCNC driver board there was a wiring guide included.
I've got vextra PH motors as well, with the .9deg per step.
Not sure if this is of use to you:
A Black a Orange Com Blk/wht Org/wht Com Red/white/ yellow/white b Yellow B red
Hi Folks,
Does anyone know what the wiring schematics should be for this bad boy?
Cheers,
-lm
Well with my HobbyCNC driver board there was a wiring guide included.
I've got vextra PH motors as well, with the .9deg per step.
Not sure if this is of use to you:
A Black a Orange Com Blk/wht Org/wht Com Red/white/ yellow/white b Yellow B red
Phantomcow2,
thanks for the quick reply, that does help.
Cheers.
-lm
I recently was scrapping out some equipment and it had 3 of these same motors in it. Any idea of the torque rating on them. The Vexta site said that these motors were discontinued and didn't have any information on them.
If it's not nailed down, it's mine.
If I can pry it loose, it's not nailed down.
Posting Permissions
