| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Stepper Motors and Drives Discuss stepper motors, drivers and related topics here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-07-2011, 07:14 PM
| |||
| |||
hi i am design cnc driver by L297 and i connect osc by ceramic capacitor 104=100000*10e-12 and resistor 500 ohm to get frequancy 29khz i want to ask if it good with mach 3 if i set it by 20 khz or i must set it at high than that my second quest is which better chopper ic WITH L297 IS L6203 OR L298?? AS MY stepper is 4.1A PER PHASE.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| parallel port to driver problem | derkiow | Stepper Motors and Drives | 0 | 02-10-2011 11:45 AM |
| Problem- TM 2x2 driver problem - wants to put 64 bit driver in ??? | ronsii | Torchmate | 1 | 12-27-2010 04:10 PM |
| 3 phase stepper driver problem | vsystems | General Electronics Discussion | 0 | 01-13-2010 09:38 PM |
| Problem- Driver test problem... | jaru-eri | Mach Software (ArtSoft software) | 0 | 02-19-2008 05:38 PM |
| Steper Motor & Driver Problem -Please Help | Chivo | Gecko Drives | 5 | 08-29-2005 06:10 PM |
| | |
Linear Mode
