Results 1 to 1 of 1

Thread: new sch for stepper driver 3A

  1. 02-28-2011, 12:08 AM #1
    free_matrex2010
    free_matrex2010 is offline
    Registered
    Join Date
    Feb 2011
    Location
    egypt
    Posts
    25
    Downloads
    0
    Uploads
    0

    new sch for stepper driver 3A

    HI

    I MAKE THIS DESIGHN FOR my stepper motor 3A
    i need u to comment if there r any problem in that
    when i fixed the component in test board the l298 has been damege
    i dont know why
    i buy new one but olso damage
    Attached Thumbnails Attached Thumbnails new sch for stepper driver 3A-loll.pdf  

« nema 17 and a3982,what lead screw and voltage | Would like to increase IPM cutting speed »

Similar Threads

  1. Newbie- Best MOSFET Driver and MOSFET choice for an H-Bridge Stepper Driver?
    By joprinz in forum General Electronics Discussion
    Replies: 4
    Last Post: 04-28-2011, 04:57 AM
  2. Need Help!- Power Supply for 4 Stepper Driver 32-65VDC and 4 Stepper Motor 65V 2.3A
    By guy2b1 in forum DIY CNC Router Table Machines
    Replies: 16
    Last Post: 03-08-2011, 06:50 AM
  3. Need Help!- 6 leads stepper motor connect to TB6560AHQ stepper driver board
    By wf1318 in forum Stepper Motors and Drives
    Replies: 2
    Last Post: 07-25-2010, 03:19 AM
  4. Wanted DIY stepper driver circuit for 6 wire stepper motors
    By Colin300 in forum Australia, New Zealand Club house
    Replies: 5
    Last Post: 09-20-2007, 10:20 PM
  5. STEPPER DRIVER FAQ {Stepper/driver amp per phase match.
    By huios in forum Stepper Motors and Drives
    Replies: 0
    Last Post: 08-27-2006, 09:43 AM

Posting Permissions



About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.