VEXTA SCSD571B stepper driver

[herrcake]

Hello all,

I just started trying to build my own CNC table mill. I got from ebay some linear actuators powered by

two VEXTA UPH564H-A
5 phase 0.72 deg / step
d.c 1.4 A
res 1.4 ohm

one VEXTA UPX534M-A
5 phase 0.36 deg / step
d.c 0.75 A
res 5.6 ohm


each with a VEXTa CSD5714B controler.


I am trying to run them, but lack all the controller specifications. Vexta doesnt have them online, so was wondering if someone might have the specs that I can use.

Thanks for your help.

[manmardam]

please take a photo from driver.
i have a CSD5714D.

Amir

[herrcake]

thanks Amir,

I relialized the driver is the same that you have . Do you happen to have the specs of the driver? I got the japanese specs from oriental motors, but it is very difficult to understand what all the signals are for, well thanks again for the reply. Best Regards, Carlos.

[manmardam]

i dont have specification, but i success run it.
is it possible share your specification(japanese specs) ?
this is my driver, is similar?

Amir

[prof_hazem2]

Originally Posted by herrcake Hello all, I just started trying to build my own CNC table mill. I got from ebay some linear actuators powered by two VEXTA UPH564H-A 5 phase 0.72 deg / step d.c 1.4 A res 1.4 ohm one VEXTA UPX534M-A 5 phase 0.36 deg / step d.c 0.75 A res 5.6 ohm each with a VEXTa CSD5714B controler. I am trying to run them, but lack all the controller specifications. Vexta doesnt have them online, so was wondering if someone might have the specs that I can use. Thanks for your help.

i have the same spec of the first stepper
and i try to run it
so please don't give up

[daki85]

I have the same driver (CSD5714B) and same problem, i do not have the specification, if anyone has a solution?
how to run this thing?

Image driver
thanks

[manmardam]

pin 1&2 : power for motor(~ +24V)
pin 3&4&6 : GND
pin 5 :VCC (= +5V)
pin 7 :CW
pin 8 :CCW
pin 11: power down
pin 12 : Enable

Amir

[daki85]

Thanks Amir