k2cnc Macnine kicking out during jogging.

[Aksess]

I have a k2cnc 39x25 with gecko g320 drives when I do some jogging the drives kick out, Some moves cause them to kick out as well mostly on the x and z axis. I have enshured nothing is binding but it still kicks out. is there a setting to set this so it wont kick out so easily?

[SIMONSIGNS]

hi, I have the same machine and had the same problem on my Z axis, the problem is I can't remember what the hell was causing it.....let me have a think on it for a few mins and come back to you........

[SIMONSIGNS]

Hi, I think it was a problem is that your acceleration rate is too high. Basically your servo/ steppers are accelerating to fast. Try slowing down the speed of the servo's and try, I think that was it....

[Aksess]

I have it set at 50 I will lower it a bit and try again. thanks.

[motomitch1]

Is the current limit trimpod set to the max which is 20 amps for the g320.

[CNCRob]

I have the same machine and my z axis kicks out at over 100ipm, under that im usually ok.

[CNCRob]

Hey Aksess, I was just wondering is this a problem that just started.

[Aksess]

No it has done it ever since I have had my machine. It only does it when I contour a part. I can slow the speed down but why. I mean if it is designed to run at 300 ipm then I want it to smoke. lol I will check the trim pot tomorrow evening thanks for the help guys.