| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Stepper Motors and Drives Discuss stepper motors, drivers and related topics here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-26-2010, 12:32 PM
| |||
| |||
Ive been looking at this board around the forum. I was just wondering what the best motor is for it. From what i've seen a NEMA 17 that I think would work best. They are 1.6A & 2.5mH motors. This gives the motor a max voltage of around 50 volts but the driver can only do 36 volts. How well would it run this motor? Thanks Telly  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| need help with tb6560 board | terryt | General Electronics Discussion | 94 | 03-14-2012 12:08 AM |
| Mac 3 setup for TB6560 controller board | davidarf | General CNC (Mill and Lathe) Control Software (NC) | 1 | 07-27-2011 02:31 AM |
| Need Help!- Current setting for TB6560 3-axis board (eBay) | leaveme | DIY-CNC Router Table Machines | 4 | 06-24-2011 03:55 AM |
| need help with 3 AXIS (TB6560) CNC DRIVER BOARD | Jason Miller | General Electronics Discussion | 34 | 01-06-2011 12:25 PM |
| Newbie- TB6560 board and motors (ebay) | cerberos | Stepper Motors and Drives | 8 | 08-12-2010 10:48 PM |
| | |
Linear Mode
