| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Stepper Motors and Drives Discuss stepper motors, drivers and related topics here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-25-2010, 02:35 PM
| |||
| |||
I am building my own CNC router and am trying to get the KL5056 microstepper drivers setup for the proper current. I know this is something likte the horsepower resistor for a brush dc motor driver board. I was told by Keling to use bipolar parallel for the motor wiring configuration and per spec sheet (see link below) that shows 6.3 amps/phase. The KL5056 has a range from 1.4-5.6 amps dc. Can anyone please tell me what I'm missing here?? Thanks, Brian http://kelinginc.net/KL34H280-45-8A.pdf http://www.mjcnc.com/download/5056%2...h%20Manual.pdf  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem- Low Current interface, High Current Motor? | Clackvalve | General Electronics Discussion | 15 | 05-13-2010 12:42 PM |
| Newbie- How do I choose a servo to match my current setup? | BiggerHammer | Servo Motors and Drives | 4 | 01-12-2010 10:01 AM |
| KL5056 runs one way only | Filobus | Automation Technology Products | 2 | 09-10-2007 08:52 PM |
| Setup / Calibration of Limit & Home switches | John3 | Fanuc | 5 | 08-04-2007 08:32 AM |
| The relationship of limit switches to home switches. | MikeAber | General Electronics Discussion | 4 | 11-04-2004 01:28 PM |
| | |
Linear Mode
