| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Stepper Motors and Drives Discuss stepper motors, drivers and related topics here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-29-2010, 05:11 PM
| |||
| |||
Hi, new to the forum and cnc stuff. I have three bipolar motors (23hs8404 motion king) they are like nema 23's but double stacked (76mm long). The motor current rating is 4.2 A per phase, does that mean the motor will draw 4.2 amps or up to 4.2 amps ? does the cuurent drawn depend on load/ voltage ? what voltage would be safe for this motor. Also, can i use the 3 axis controller from ebay with these motors ? (uses Toshiba chips TB6560) each chip will do 3.5 A peak Thanks in advance for any help/suggestions. wildbill.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bipolar motor controller. | Jolijar | DIY-CNC Router Table Machines | 1 | 02-12-2010 05:03 PM |
| Motor controller bipolar of unipolar? | DimiOrla | Open Source Controller Boards | 19 | 02-19-2007 09:12 PM |
| Current Regulated Bipolar Driver | SteveT44 | General Electronics Discussion | 17 | 11-28-2005 08:39 AM |
| High current motor controller | TinkerDJ | RC Robotics & Autonomous Robots | 1 | 11-27-2005 02:56 PM |
| Gecko power supply 2/3" current rating? | JFettig | Gecko Drives | 4 | 01-06-2005 08:04 AM |
| | |
Linear Mode
