03-14-2010, 07:15 AM
|
| | | Join Date: Mar 2010 Location: Turkey
Posts: 1
| |
I've bought MC433G controller DRO48(digital readout) , CJ14 Joystick and MCUSB10 from Soc-Robotics.
I received them last week.It was really pain for the first startup but finally got movement from the step motor with the test utility.
Anyway ,while I was programming the new motor controller software I forgot to remove the programing jumper and send some Gcodes which locks the motor controller processors (ATmega168s).
Mc433g programming software says
x2-x3-x4-x5 motor controllers are not responding-either faulty or not installed.
-xa command says,
Reset x2-x3-x4-x5 : Target not responding to enable serial programming command.
While instaling the new Hex files program can not even earase the chips .
By the way I can not write the new software hexfiles to chips so that they are not responding to serial programming command.
Any idea and solution how to release them pls......
I have asked the Soc-Robotics but not answered already . |
Similar Threads 
Linear Mode
