I have a problem with the chinese stepper drive i bought. The driver is HY-DIV268N-5A.
My problem is that the motor will not turn. As i power up the driver the motor will freeze into position, so i know it does receive current. But as i try to turn it it will not turn. I set the pins in the Mach3 to active low, and wired the driver like in the photo.
I swaped the pins on the Break out board with the pins from a driver that i know works to check if the pin work( as my 2 first pins on the Bob do not), and they do. I wired the stepper to another driver (dq860ma) to check the motor and it works.I tried connecting the EN+ to my +5v but no change. I am stumped as to what is wrong.
http://www.cnczone.com/forums/attach...d=369754&stc=1