Buy new drivers until 100€

[macinblack]

Hello guys, I want to replace the TB6560 of my CNC 6040 4 axis, and I have a low buget (100€). I saw this drivers from a user of this forum Slowing 69.16.243.61&c=1&t=42942.2870150463
is this the best deal?
Regards

Similar Threads:

• Stepper motor&drivers,servo motors&drivers,motion control card CHINA factory
• IMS drivers vs. Gecko drivers
• Can i use these drivers
• Has anyone used these drivers
• Drivers - Help!!!

[SteveWill]

I use these controller and I think it is the only place in the USA to buy. I have had mine for over 2 years and am very please with them, no problems.
James may post and let you know if there is a better place for you since you are in Portugal.
The board was an open source design on this site, Here a link to the thread http://www.cnczone.com/forums/open-s...395-posts.html

[Andreiir]

So u have some low cost drivers , and u want to buy more ?
Search for a dm542 drivers and try next think .