Problem SteelTailor plasma Acetylene gas cutting table parameters and THC operation guide

Results 1 to 1 of 1

Thread: SteelTailor plasma Acetylene gas cutting table parameters and THC operation guide

  1. #1
    Registered
    Join Date
    Nov 2013
    Location
    Beijing China
    Posts
    171
    Downloads
    0
    Uploads
    0

    Smile SteelTailor plasma Acetylene gas cutting table parameters and THC operation guide

    (Q) can you send us Acetylene gas cutting table parameters
    SteelTailor plasma Acetylene gas cutting table parameters and THC operation guide-1-jpg
    Notice the cutting data condition:
    1. The purity of oxygen should not be less than 99.5%.
    2. Carbon of steel plate should be ≤0.45%.
    3. Cutting method should be vertical cutting.
    4. Oxygen pressure given is preheat oxygen before cutting.

    (Q) THC operation guide
    SteelTailor plasma Acetylene gas cutting table parameters and THC operation guide-2-png-THC Operation guide
    ST-THCEX03
    SteelTailor plasma Acetylene gas cutting table parameters and THC operation guide-3-png

    Height: 0-30(60-160)
    It is the expected value of the torch height, set by users. Larger the value, working height will be set higher.
    60~160 is the value you will see in the display
    Cutting Height, It is the relative height the THC maintains for the ARC voltage.


    Sensitivity: 0-10
    To adjust the sensitivity of the THC. To increase the sensitivity of THC lowers this value. Height ± Sensitivity value the THC will not be adjusted its height.


    IHS Height: 0-100(0-12) mm
    Before pierce, the torch will go down and touch the plate, then the torch will be lift to a certain height, this height is the IHS height. 0~12 mm is the height the can be adjusted
    The initial piercing height.

    SteelTailor plasma Acetylene gas cutting table parameters and THC operation guide-5-gif
    1.This display on the first digit shows, the THC is in ARC voltage mode

    2.This display on the first digit shows, the THC is moving UP

    3.This display on the first digit shows, the THC is moving DOWN

    4.This display on the first digit shows, the THC reached HIGH LIMIT

    5.This display on the first digit shows, the THC reached LOW LIMIT


    More information about SteelTailor FAQs, Pls visit:
    Forum - Powered by Discuz!

    Hope this is helpful to you .
    Any other question ,pls email at service@steeltailor.com.
    You can also find us easily on facebook:SteelTailor Twitter:SteelTailor,

    Similar Threads:
    Last edited by Steel Tailor; 07-14-2015 at 01:37 AM. Reason: picture not show
    SteelTailor--The world leader of portable CNC cutting machine
    www.steeltailor.com


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

SteelTailor plasma Acetylene gas cutting table parameters and THC operation guide

SteelTailor plasma Acetylene gas cutting table parameters and THC operation guide