There are new questions with using portable cutting machine.

(Q)How to check START Signal and if the wire or connectors are okay?

(A)SteelTailor Portable CNC cutting machine how to check START or FINISH Signal?-20150602-png
See if the cable is short even when CNC 2 cable is removed from the connector. If the cable is not showing shot when the CNC 2 cable is not connected to the CNC machine electrical box then do step 2.

(Q)How to check FINISH Signal and if the wire or connectors are okay?

(A)In the SteelTailor CNC cutting machine,Shot circuit finish 2 wires with a small wire.
SteelTailor Portable CNC cutting machine how to check START or FINISH Signal?-20150602-1-png

Go to DIAGONOSE mode
When you shot circuit the 2 wires see if the state of the DLZ changes to 0 and when remove the short see if the state change back to 1
SteelTailor Portable CNC cutting machine how to check START or FINISH Signal?-20150602-2-png

More information about SteelTailor FAQs, Pls visit:
Forum - Powered by Discuz!

Hope this is helpful to you .
Any other question ,pls email at service@steeltailor.com.
You can also find us easily on facebook:SteelTailor Twitter:SteelTailor,

Similar Threads: