| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Steam Engines Discuss your live steam engine creations here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
 
05-12-2009, 07:50 PM
| |||
| |||
| One of my designs I was going to have the disk and washers cut out on the water jet to fit a drive shaft with two opposing sides machined away. The drive shaft would have been threaded and clamped down with a bolt. I would have put some kind of machine screw or something through the washer ends rather than rivets.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Nikola Tesla Medal Engraved via CNC | dcarr | CNCzone Club House | 11 | 02-23-2008 12:46 PM |
| Tesla | Unition | Environmental & Alternate Energy | 31 | 01-05-2008 11:29 AM |
| | |
Linear Mode
