![]() | |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| SprutCAM Discuss SprutCAM software here. |
| This forum is sponsored by: |
![]() |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
| |||
| |||
| CRC errors in program downloads I'm just wondering if anyone else has experienced problems in downloading files from Sprutcams site. I have tried numerous downloads and each time when I go to extract a file I get an error message that there is a CRC error in the file. Does anyone know how to get around this issue? |
|
#2
| ||||
| ||||
| Typically, I would think this might be a problem with your network card. However, files from anywhere would probably have the same issues. Perhaps the files are corrupted by some sort of compression utility? Run a virus check on your system as well, just in case.
__________________ First you get good, then you get fast. Then grouchiness sets in. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
| |||
| |||
| HuFlungDung, I tried downloading on different computers but from the same internet connection with exactly the same result. The system where I work is too slow and just times out. |
|
#4
| |||
| |||
| I haven't had any outright download failures lately, but it can sometimes take an hour or so to download the latest revision. Mike |
![]() |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SCM Record 1 manual, infos, downloads ? | degressor | CNC Machining Centers | 26 | 07-29-2011 06:49 PM |
| Mastercam library downloads? | Nate0918 | Mastercam | 4 | 11-18-2008 07:33 PM |
| Posting in Downloads section | anorec | Forum Questions or Problems | 4 | 06-22-2007 03:21 PM |
| Linspire offering free downloads until 9/6/05 | mvaughn | CNCzone Club House | 0 | 09-03-2005 11:00 PM |
| Software Downloads | signIT | DIY-CNC Router Table Machines | 2 | 04-01-2005 11:20 AM |