Curious Error

[_swede]

Hi guys,

I just got an error pop-up running SprutCAM 2007 Master on a machine dedicated for my Tormach PCNC1100. Does anyone recognize it???

It goes as follows:

"Access violation at address 00A54DD0 in module 'SCKernel.dll'. Read of address FF0014BE."

I was only a couple minutes into a project, so I didn't lose much when it crashed. I re-opened a new project and it occured again at a different point of setup. It's just odd because I produced an almost identical project earlier today on another machine with no errors.

My intuition leads me to believe it's probably an error resulting from my graphics drivers/card. I'm going to update them now..

Any comments would be great!



v/r

[Fishy]

Hi Swede,

There is a video regarding this error on the SprutCam UK site. I hope the link works for you....

http://www.download.sprut.co.uk/Foru...ion_errors.htm

Regards,
Fishy