SprutCAM, Should have done this before.

[borrisl]

I'm a new user of SprutCAM. I have to admit it, things in this little market are just plain expensive. I thought I'd go the cheap route and started with BobCAD. I've done a few things on it, it works, but.... Even for me, a newby, I found BobCAD too teadious. Too many steps to get the code I needed. MasterCAM was too expensive, solidcam, surfcam, featurecam, all fall under this category. However, SprutCAM gave me most of the features of the high end, high dollar stuff but at a reasonable price. I hope to attract more users of it to this board.

No, I'm not paid to post these... a discount would be nice though. Thanks Sprut!

[saturnnights]

Originally Posted by borrisl I'm a new user of SprutCAM. I have to admit it, things in this little market are just plain expensive. I thought I'd go the cheap route and started with BobCAD. I've done a few things on it, it works, but.... Even for me, a newby, I found BobCAD too teadious. Too many steps to get the code I needed. MasterCAM was too expensive, solidcam, surfcam, featurecam, all fall under this category. However, SprutCAM gave me most of the features of the high end, high dollar stuff but at a reasonable price. I hope to attract more users of it to this board. No, I'm not paid to post these... a discount would be nice though. Thanks Sprut!

((sigh))
No pricing on their site - if you don't mind me asking, how much is SprutCAM?

Mark

[opua]

according to their web site cost of program is $3200.00

[saturnnights]

Originally Posted by opua according to their web site cost of program is $3200.00

Now I feel stupid - I was at their website and didn't see that

Thanks!

[Krisz]

The Machinist 2-2.5D version starts at $1800US
Contact me if you have any further questions, or visit my site for more information at http://www.sprut.ca

[dneisler]

If you need a CAD program to, call Alibre, I am working a HECK of a deal with them for a lot less than $3200 for the expert one.

[Krisz]

Yes Alibre is pretty good for CAD. It is cheap too and the maintenance cost is low as well. I went with them for the CAD package. Although SprutCAM is only included in the Alibre Expert Edition and it is only a 1 year license, after that you have to purchase SprutCAM. Also Alibre does not give you any support to SprutCAM. But their CAD software is unbeatable in the price category.

[dneisler]

Krisz,
Can you tell me if the SC that is with alibre is changed after there 90 day period. I have seen forum post that say yes, and some that say no.

[Krisz]

The SprutCAM version that you get with Alibre is the exact same version as what you can purchase with the exception of it will only work for 90 days or 1 year depends on the version of the Alibre Design that you purchase or the deal you got from Alibre. Also the version you get from Alibre comes with no support at all no manual and no hardware key. So in a sense it is the same and in other it is not.

[jasonwinters]

Originally Posted by Krisz Also the version you get from Alibre comes with no support at all no manual and no hardware key. So in a sense it is the same and in other it is not.

Is the pdf listed on the website as the manual not the same as you get with the product? (just not printed, right?)

Ciao!

Jason

[Krisz]

yes that is correct

[MichaelHenry]

Is a professionally printed manual printed manual of SprutCAM 4 Expert available?

Mike