Hi everyone, first post here. I am trying to open an Alibre IGS file in Sprutcam, the drawing is in MM and Sprutcam is set to MM, i have double checked.
The message I get is titled " Import Scaling" then Current Sprutcam units: MM
Input model units: CM
Scale factor :10, Do you want to scale the imported model, YES / NO
I have just put build 1.5 Rev 45786 in
This is my first go at using Sprutcam so I could well have set something up wrong
EDIT I just opened the file by clicking YES and measured it with the measure tool, the measurements are as per the
drawing? Could this be a quirk with this release?
Last edited by wbleeker; 05-05-2012 at 05:00 AM. Reason: Additions
Sounds like in Alibre you have units set to CM and SprutCam is in MM and is asking if you want to scale the iges model to MM (yes option) or leave it at CM (no option)? Maybe double check your units in Alibre?
Currently using SC7 Build 1.6 Rev. 64105