Need Help!- Sprutcam

[ErnieD]

Hi,

I have Sprutcam that I bought from Tormach loaded in my computer and I have Sprutcam that I downloaded from the internet. I recently had a hard drive crash and I cannot run the Sprutcam that I purchased. I would also like to get rid of the Sprut that I downloaded from the net. Problem, I did not put each one of these in its own folder and the files are intermingled.

Any ideas about how to do this. Eric, if you are watching, would it be better if I deleted all of these files and then do a fresh load of Sprut?

Thanks,

Ernie

[Gerry Sweetland]

Hi Ernie,
I would go to Control Panel and un-install SprutCam in the Uninstall Programs utility. Then delete the original install location folder. Then install the version you bought from Tormach.
Gerry

[Eric_Tormach]

Ernie, The best course of action is to uninstall all the versions, and then only install the purchased version off the CD (this has the licensing information that corresponds to the dongle) After that version is installed you can overwrite it with any newer version and your dongle should be ok.

[ErnieD]

Hi Guys,

Gerry, I successfully accomplished the uninstall and re install. Thanks.

Eric, Same as above. FYI I had a computer crash so I ordered and received a new controller from Tormach and I am up and running again. I have not tried to cut anything yet but will have a go at it today.

Thanks to the both of you for your prompt replies.

Ernie