Pocketing Issues

[s2jesse]

http://imageshack.us/photo/my-images/192/31744938.jpg


any idea why that second step is not round? Basicaly that is a few seperate pocketing operations. I created them by clicking on the edge of each hole and selelected the bottom faces as the bottom level. Top level is always 0.

That one hole is just odd... if i switch it to a 3/8 cutter it smooths out fine however it is plenty large for a 1/2"

Any ideas?

[beanbag]

Maybe it is an issue with the tolerance setting in the simulation. Look at the actual code in the simulation to see if it is a circle. Otherwise, check the settings for "admissible deviation" or "smooth corners" in the parameters settings.

[s2jesse]

hrm Its not tolerance i jacked that up same non round edges there. The curve path itself does look round thoough but the simulation obviously moves sharply. I'll play with some of the other settings you mentioned.

[s2jesse]

hrm nope smooth corners is OFF and admissible deviation is inner 0.0 and outer 0.00003

[s2jesse]

does look like its just the simulation the actual part milled fine for anyone else with the issue