Sprutcam pocketing bugginess - CNCzone.com-The Largest Machinist Community on the net!

beanbag · #1 11-11-2011, 02:43 AM

WTF is this?

Didn't notice the gouge until after machining.
This is using the pocketing "ridge" operation around a curve + .015 radial stock.
SC 7.1.5.

flyinchips · #2 11-11-2011, 01:46 PM

Did you report it to support? It won't ever be fixed unless you do......
If you're lucky, they will also show you a way to fix it today.

dbrija · #3 11-11-2011, 07:58 PM

I'd look at the tolerances you specify in the operation. I have fixed these type of anomalies by relaxing or tightening the tolerances.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need help with pocketing	blondemale35	Machines running Mach Software	7	04-07-2011 07:11 PM
Need help with pocketing!	wdp67	BobCad-Cam	4	01-18-2008 03:41 PM
help with pocketing on MCX	genexis	Mastercam	9	06-29-2007 10:35 AM
pocketing	signIT	DIY-CNC Router Table Machines	7	06-06-2006 09:04 AM
Pocketing	dneisler	BobCad-Cam	4	12-18-2005 10:57 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)