Work Offset Coordinate System G59 Pxxx

[SpruTormaCam]

I've got a SprutCam question that I have been wasting way way too much time on.

I would like to use fixture offsets other than G54 - G59, for example G59 P10. I'm using my Tormach 1100 as a VLathe and have multiple turning tools set up gang style and want to use the extended coordinate system for this project.

I haven't figured out how to do that with SC7 other than going back and editing the post.

I wouldn't think SC7 would just support 6 offsets so I'm assuming there is an easy step I'm missing.


Thanks, Mark...

Tormach 1100 sII w/ATC
SC7 1.5 rev 45534

[dbrija]

Originally Posted by SpruTormaCam I've got a SprutCam question that I have been wasting way way too much time on. I would like to use fixture offsets other than G54 - G59, for example G59 P10. I'm using my Tormach 1100 as a VLathe and have multiple turning tools set up gang style and want to use the extended coordinate system for this project. I haven't figured out how to do that with SC7 other than going back and editing the post. I wouldn't think SC7 would just support 6 offsets so I'm assuming there is an easy step I'm missing. Thanks, Mark... Tormach 1100 sII w/ATC SC7 1.5 rev 45534

Just click the Machining tab, and in the box at the lower left, where it says Global CS, click, and you get a pull down menu, and another button with 3 dots. Hit the 3 dot button, and when the dialog pops up, enter the desired number in the LCS box (i.e. 59.100). See attached screenshot.