2d Contouring - CNCzone.com-The Largest Machinist Community on the net!

scottsss · #1 10-04-2011, 05:10 PM

Ran into a problem getting 2D contouring to work. I've selected the outer border, set the endmill and went with default settings but nothing...I know its something simple. Thanks

scottsss · #2 10-04-2011, 05:48 PM

Figured it out....I was trying to use the workpiece to select the curve rather then the job assignment.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Help with 3D contouring	Kevin77	Dolphin CADCAM	6	06-02-2010 05:55 AM
Problem- 3D contouring basics?	Donkey Hotey	Mastercam	17	02-03-2008 10:44 PM
Help Need Help With 3d Contouring	D5PENNIES	Hobby Discussion	0	04-02-2007 08:24 PM
3D Contouring????????	cut2spec	Benchtop Machines	4	03-18-2007 01:08 PM
contouring help	rbest27	Surfcam	2	02-02-2007 09:14 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)