Very slow saving file - CNCzone.com-The Largest Machinist Community on the net!

C*H*U*D · #1 09-05-2011, 11:18 PM

I am using 7.1.5.45760 and noticed that it takes a very long time to save the file I am working on. It actually shows "Not Responding" at the top of the SprutCAM window, and I almost shut it down the first time it happened. Eventually it saves the file and starts responding again. Has anyone else noticed this?

bevinp · #2 09-07-2011, 03:39 AM

What size is the file once saved?
There is an option in the Save screen "Short" and "Detailed". Detailed save will save the generated toolpath, whereas Short does not.

C*H*U*D · #3 09-07-2011, 12:02 PM

It's just under 1.5mb, which is why I found it odd that it would cause SprutCAM to stop responding.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem- V23 crashing when saving file as DXF or DWG	Chipload	BobCad-Cam	1	01-10-2010 01:09 PM
Newbie- Saving a file	bjm323	Mastercam	4	11-23-2008 11:22 AM
Newbie- Saving file	bjm323	Mastercam	1	10-15-2008 06:05 PM
Saving a File	utahnorton	AjaxCNC Control Products	0	12-28-2006 09:10 PM
Saving a Text file?	Scott V	BobCad-Cam	4	11-23-2004 08:27 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)