Alibre Key Mapping - CNCzone.com-The Largest Machinist Community on the net!

MichaelHenry · #1 05-08-2011, 10:59 AM

I've set Key Mapping to the Alibre type in Tools | System Setup | Visualization but the Alibre method of panning and 3D rotating the model doesn't seem to be working. Is there a secret to getting it to work properly, maybe by changing an XML file?

This is in SprutCAM Pro Version 7, Build 1.3, Rev 42692.

Thanks, Mike

cgroves · #2 05-08-2011, 11:29 PM

Hello Mike,

Sorry I can't help but you're not alone in having that problem. I've never been able to get that to work.

Christian

MichaelHenry · #3 05-09-2011, 02:00 PM

Thanks Christian - at least I won't have to waste time re-installing. If I find or hear of a solution I'll post back hear.

Mike

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
post help - mapping scheme	thermgood	Post Processors for MC	0	09-12-2010 06:50 AM
Alibre CAM coming in Alibre Expert 10	MichaelHenry	Alibre Design	2	06-16-2007 01:57 PM
mapping the leadscrew	sdantonio	Mach Mill	9	04-18-2007 07:22 PM
Bump mapping	MrRage	General CAM Discussion	0	09-02-2005 04:43 PM
Geometry mapping	DieGuy	General CNC (Mill and Lathe) Control Software (NC)	2	04-28-2005 09:37 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)