Results 1 to 2 of 2

Thread: Correct SprutCam Haas Post for TM-1

  1. #1
    Registered
    Join Date
    Oct 2005
    Location
    USA
    Posts
    77
    Downloads
    0
    Uploads
    0

    Correct SprutCam Haas Post for TM-1

    Does anyone knw which of the numerous "Hass posts" supplied by Sprut Technologies for SprutCam should be used for a Haas TM-1 mill? I started with a trial and error method, but found out the hard way that some of them don't even correctly post important commands (such as M3!). Others post words for advanced features not supported by the TM-1.

    Thanks,
    -Brian


  2. #2
    Registered
    Join Date
    Mar 2011
    Location
    USA
    Posts
    2
    Downloads
    0
    Uploads
    0
    I am having the same problem finding a post processor that will work with my HAAS mini mill. If you find one that works for the TM1, could you pass it along? it might work for mine as well.

    So far a couple posts that seem fairly close are the HAAS(s) post, and the Haas(2) post from the sprutcam website. However, I can't get either of these posts to output code with cutter radius comps turned on. weird.

    I am also getting an alarm #304 error message on all of the six or so different posts I have tried. It says somethign about an invalid I,J, K and radius at start and end not matching up. If you have any ideas, I would be thrilled to get some suggestions.

    Also, if I get a post that works, I will pass it on.

    Thanks,

    Travis


Similar Threads

  1. Mach3 Post Processor for SprutCAM 4
    By asammons in forum Mach Software (ArtSoft software)
    Replies: 9
    Last Post: 03-28-2013, 02:11 AM
  2. Replies: 0
    Last Post: 03-31-2010, 10:04 AM
  3. Need Help!- Upgrade to SprutCam 5.50, Now I can't run my post
    By TMashino in forum Tormach Personal CNC Mill
    Replies: 7
    Last Post: 02-27-2009, 07:22 AM
  4. Need Help!- What's the correct post processor code for EMC2?
    By OneAndy in forum General CAM Discussion
    Replies: 2
    Last Post: 10-18-2008, 10:05 PM
  5. Looking for the correct post processor
    By twooten in forum Post Processor Files
    Replies: 0
    Last Post: 01-22-2008, 03:55 PM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.