where to get SC updated? - CNCzone.com-The Largest Machinist Community on the net!

eeenhy · #1 06-30-2010, 12:21 PM

Hi,

when I got to the sprutcam main page and click to load the latest version, version 8, it takes me to an empty FTP directory?

Is it just me, or is it really empty?

Ian

eeenhy · #2 06-30-2010, 08:00 PM

It must have been a temporary glitch, I can see the file now.

HOWEVER, when I install SC7, it will not run. When I click on the icon, nothing happens. If I look in windows task manager, under processes, I see "Sprutcam.exe" appear for about 1 sec, then it disappears again. No windows or warnings appear.

When I run SC2007 w/o the dongle attached, at least it pops up a warning message. I am running on Vista 64 bit (unfortunately).

eeenhy · #3 07-01-2010, 11:54 AM

Ok, Eric at Tormach fixed my problem for me.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Updated website let me know what you think?	microfusion	CNCzone Club House	3	04-22-2010 02:22 PM
Updated Vac Shoe	IQChallenged	CNC Wood Router Project Log	0	10-24-2009 06:32 PM
Problem- Two OM-s, different behaviour [UPDATED]	padobranac	Fanuc	7	09-20-2008 06:40 AM
Updated forum anything missing?	CNCadmin	CNCzone Site News and Contests	19	11-09-2007 08:39 PM
MiniDRIVEDC+ updated	Vider	Servo Motors and Drives	0	06-15-2005 03:58 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)