Maybe set PD002 = 1 ?
So I am trying to control my VFD from an external source. Turns out the settings are the same for using the onboard potentiometer. is there a way to bypass the pot without tearing it open and removing it? I know there have been many threads about this VFD and I have been looking for hours and still have no idea what I am doing...
thanks in advance
Similar Threads:
Maybe set PD002 = 1 ?
Jim Dawson
Sandy, Oregon, USA
that sets to external control which you would think would be the right choice... but thats what said potentiometer seems to run off..
Maybe someone else has the answer, that's the only thing I saw in the manual that made sense.
Jim Dawson
Sandy, Oregon, USA
It depends on what the source is.
You need to change both PD001 and PD002.
And there's a jumper J1 that needs to be moved.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)