Need Help! Need Al_The_Man's Help!!!


Results 1 to 3 of 3

Thread: Need Al_The_Man's Help!!!

  1. #1
    Registered
    Join Date
    Mar 2010
    Location
    America
    Posts
    526
    Downloads
    0
    Uploads
    0

    Default Need Al_The_Man's Help!!!

    Hi Al,

    On my Huanyang VFD with out Amps set for display I receive 0.0 to 0.3 averagely. How am I to interpret this? Is this additional Amps to my set amps in (PD142). I can't imagine it being my total amp draw when running.

    Thanks in Advance,
    Dan


    Anyone else with a answer will be extremely appreciated.

    Similar Threads:


  2. #2
    Community Moderator Al_The_Man's Avatar
    Join Date
    Dec 2003
    Location
    Canada
    Posts
    22050
    Downloads
    0
    Uploads
    0

    Default Re: Need Al_The_Man's Help!!!

    I don't have the manual where I am right now, but IIRC PD142 just sets the plate current of the motor so you don't exceed it an possibly burn the motor out.
    I will check later.
    Are you talking front read out or the analogue meter output?
    Al.

    CNC, Mechatronics Integration and Custom Machine Design

    “Logic will get you from A to B. Imagination will take you everywhere.”
    Albert E.


  3. #3
    Registered
    Join Date
    Mar 2010
    Location
    America
    Posts
    526
    Downloads
    0
    Uploads
    0

    Default Re: Need Al_The_Man's Help!!!

    Quote Originally Posted by Al_The_Man View Post
    I don't have the manual where I am right now, but IIRC PD142 just sets the plate current of the motor so you don't exceed it an possibly burn the motor out.
    I will check later.
    Are you talking front read out or the analogue meter output?
    Al.
    The front read out. On the huanyang there is a display choice for this "out amps" there's also a read for modbus for out amps both displaying the same. Just not sure how to interpret the read. It increases and decreases while spindle spins up or down. Making cuts it increases as well, been deliberately making deep cuts and went up as far as 1.6. but under no load it's 0.0 - 0.3.

    Been searching the internet and learned a lot with running and full load amps but still no answer. I knew you were the best choice to get close. Thanks or your reply and have a Happy Easter Sunday!

    Dan



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Need Al_The_Man's Help!!!
Need Al_The_Man's Help!!!