New spaceclaim forum

[patriqq]

Quote from Post # 13 ???

[martinkopplow]

Quote from Post # 13 ???

I don't understand what you are telling me here ... ?

Martin

[patriqq]

Disregard my comments. They were in response to a post that was here last night, but has apparently been deleted. The post was a word-for-word quote from post # 13:


Dear patriqq,

millkito03 has just replied to a thread you have subscribed to entitled - New spaceclaim forum - in the SpaceClaim forum of CNCzone.com-The Largest Machinist Community on the net!.

This thread is located at:
New spaceclaim forum - Page 3 - CNCzone.com-The Largest Machinist Community on the net!

Here is the message that has just been posted:
***************
I am a long time Solidworks user, and can model really well in SW. As powerful as SW is, I have been frustrated by SW in the past, and have lost tons of work when I had changes that gave me the old "rebuild error" and I had to go backward 25 steps. When I didn't think through my model 100% before building it.
***************