- New to CNC (Wilmington NC Area)
-
Member
New to CNC (Wilmington NC Area)
Experienced machinist, just acquired a Klondia FV1 CNC with Dynapath Delta 20 controller. I can run machine in jog mode, but moving beyond that is a challenge. Anyone in the Wilmington/Jacksonville area willing to help a newby out?
I have the Dynapath manuals, and have MasterCam X Mill loaded on the Mill connected computer. The mill is setup to receive programs from the computer and can take (so I'm told) drip-feed, if needed.
Similar Threads:
-
- New to CNC (Wilmington NC Area)
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules